Hey. I have installed this firmware, tested ABL and it works much better than on official firmware.
After that i have tried to print something though and run onto serious problems.
Most of the times, i submit the job, the hot end only heats up to 175C, regardless of the hotend temp set in slicer.
After several attempts, i finally managed to submit a print job, after which the hot end warmed up to 205C, i think that the printer actually started printing, but the extruder was constantly trying to retract the filament keeping the hotend empty.
Hey. I have installed this…
Hey. I have installed this firmware, tested ABL and it works much better than on official firmware.
After that i have tried to print something though and run onto serious problems.
Most of the times, i submit the job, the hot end only heats up to 175C, regardless of the hotend temp set in slicer.
After several attempts, i finally managed to submit a print job, after which the hot end warmed up to 205C, i think that the printer actually started printing, but the extruder was constantly trying to retract the filament keeping the hotend empty.