I tried compiling this using the PlatformIO instructions on my 4.2.2 board. I've recently updated my usb drivers to connect via windows 10 but I get the same stk500_getsync() issue that other people had and I have all the baud at 115200 bps, 8 bit and no parity. Just as a sanity check, I booted up cura and octoprint and was able to control the printer from both of those. I also tried it with and without an SD card. I was having problems with the BLTouch's G29 command using the Marlin 1.1.2 so I was hoping recompiling with the latest version would fix this. Last thing to note, visual studio is yelling at me about a missing include folder but I assume that isn't important. Any help would be appreciated.
Does this work with the new 4.2.2/4.2.7 boards?
I tried compiling this using the PlatformIO instructions on my 4.2.2 board. I've recently updated my usb drivers to connect via windows 10 but I get the same stk500_getsync() issue that other people had and I have all the baud at 115200 bps, 8 bit and no parity. Just as a sanity check, I booted up cura and octoprint and was able to control the printer from both of those. I also tried it with and without an SD card. I was having problems with the BLTouch's G29 command using the Marlin 1.1.2 so I was hoping recompiling with the latest version would fix this. Last thing to note, visual studio is yelling at me about a missing include folder but I assume that isn't important. Any help would be appreciated.