Add new comment

Submitted by Gregg Lachterman on Tue, 11/10/2020 Permalink

First, I thank you for the earlier assistance. I did get compiled and uploaded.

I have a new question.

As I mentioned in earlier email I am quite new to all of this. I went to perform the bed leveling routine but get a message that probe failed.

I am using the original bracket from the bltouch upgrade kit for creality printers

Are you familiar with the bracket that comes shipped in a combo kit? Are you able to give me guidance where I might change the settings for bltouch? (3.1)

 

Thanks

Gregg 

 

The content of this field is kept private and will not be shown publicly.
CAPTCHA
7 + 7 =
Solve this simple math problem and enter the result. E.g. for 1+3, enter 4.
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.
Protected by Spam Master