power outage Hello,if you enable power outage feature and store settings then the printer halted at the start of any print. For some reason, Bigtreetech SKR v2.0 board waited for a signal from the corresponding pin on the motherboard for this feature to work. Can you resolve this issue in the mesh firmware? Reply
power outage
Hello,if you enable power outage feature and store settings then the printer halted at the start of any print.
For some reason, Bigtreetech SKR v2.0 board waited for a signal from the corresponding pin on the motherboard for this feature to work.
Can you resolve this issue in the mesh firmware?