Add new comment

Submitted by drguild on Thu, 04/21/2022 Permalink

Firmware with the bltouch seems to work fine probing compared to the BTT broken one.

The Neopixle header on the SKR Mini E3 2.0 doesn't seem to work with WS2812 LED light strips or is disabled in the firmware.

Is the HOTEND_IDLE_TIMEOUT Submitted by Myzhar on Fri, 09/10/2021 being looked at or fixed?

I have the BTT Smart Filament Sensor and will hook up to E0-STOP as you mentioned, can it work in the TFT35 Touchscreen mode or just Marlin simulator?
Also does it pass the information about filament breaks to Octoprint using the host function?

The content of this field is kept private and will not be shown publicly.