Add new comment

How is your CR touch wired?

His firmware is set for bl/cr-touch with 2 pins on the z-end stop port, and the 3 on the probe port. Only the probe's 5 wires should be plugged. 3 in one port, 2 on the other. And the physical end stop switch left unplugged.

The content of this field is kept private and will not be shown publicly.
12 + 7 =
Solve this simple math problem and enter the result. E.g. for 1+3, enter 4.
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.
Protected by Spam Master