If no changes were made in the fw from this page, then, when homing Z the bl-touch probe should be centered. If it's not, bed size or offsets may have wrong values. Check if X and Y offsets are properly set, including if the value is positive or negative.
Doing that worked for me. Also remember to reset eeprom after flahing firmware, set the new values, and save to eeprom again, to clear old info. Good luck.
Offsets
If no changes were made in the fw from this page, then, when homing Z the bl-touch probe should be centered. If it's not, bed size or offsets may have wrong values. Check if X and Y offsets are properly set, including if the value is positive or negative.
Doing that worked for me. Also remember to reset eeprom after flahing firmware, set the new values, and save to eeprom again, to clear old info. Good luck.