Add new comment

Home point not centered

I just flashed this firmware last night and I have one small issue. The print head isn't homing on the center of the bed....its to the right a little bit. when I went to print it is too far over and prints off the edge of the bed. what setting do I need to change to get it back to center?

Your name

Email

The content of this field is kept private and will not be shown publicly.

Homepage

Notify me when new comments are posted

All comments

Replies to my comment

CAPTCHA

Math question 6 + 0 =

Solve this simple math problem and enter the result. E.g. for 1+3, enter 4.

This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.

Protected by Spam Master