Add new comment

Submitted by Alessio Fusaro on Sat, 10/23/2021 Permalink

You did a great job! Thank you! I use hot-end and direct drive extruder micro swiss and Satsana fan duct on Ender3 PRO. With marlin 1.x I had to set a non-standard Y_MIN_POS, in marlin 2.x I couldn't get it to work... but the easiest solution was to move the sensor end-stop physically and now everything works perfectly

The content of this field is kept private and will not be shown publicly.
CAPTCHA
3 + 17 =
Solve this simple math problem and enter the result. E.g. for 1+3, enter 4.
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.
Protected by Spam Master