Add new comment

Submitted by Michal on Fri, 01/15/2021 Permalink

Hey. I have installed this firmware, tested ABL and it works much better than on official firmware.

After that i have tried to print something though and run onto serious problems.

Most of the times, i submit the job, the hot end only heats up to 175C, regardless of the hotend temp set in slicer. 

After several attempts, i finally managed to submit a print job, after which the hot end warmed up to 205C, i think that the printer actually started printing, but the extruder was constantly trying to retract the filament keeping the hotend empty.

The content of this field is kept private and will not be shown publicly.

Markdown