Add new comment

Submitted by Nick Marino on Wed, 04/15/2020 Permalink

After flashing this version of firmware I got an error on the LCD saying Error: EEPROM. Onlything I changed was the probe offset.

Is there something else I need to do to get it to work correctly.

Also I ran initialize EEPROM in the LCD menu and that seems to work but afterwards Octoprint just kept rebooting the controller trying to connect to it.

You could see on the LCD it was just constantly rebooting. When I stopped Octoprint manually from SSH the rebooting cycle would stop.

Not sure this is 100% compatible with OctoPrint.

The content of this field is kept private and will not be shown publicly.