Add new comment

Thank you!

I ordered an avrprommer and with that I was able to reflash the bootloader. Problems are gone now. So it seems that the bootloader had become corrupt. I don't know how this happened, but I have a suspicion that it's because it's because I use OctoPrint on a RasberryPi, and the Creality mainboard is drawing power over the USB cable. There may have been a brownout condition which caused the bootloader corruption. I can't know for sure, but it's my best theory. So a word of caution for anyone with a similar setup.

Now I still have the buzzer going constantly even though I changed SERVO0_PIN to 29 in Configuration.h

Is there some other setting that affects the buzzer?

The content of this field is kept private and will not be shown publicly.
CAPTCHA
1 + 10 =
Solve this simple math problem and enter the result. E.g. for 1+3, enter 4.
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.
Protected by Spam Master