Add new comment

I have question. I have TMC board+BL touch. After flash to 2.0.5.1 I go to menu and use Auto Home. After this I go to Move Z and set 0. Now I go to Menu/Configuration/Z Probe and adjust end. Store setting. After print my printer always have 0.2 and print in air not to bed. What I do bad?

The content of this field is kept private and will not be shown publicly.
CAPTCHA
12 + 2 =
Solve this simple math problem and enter the result. E.g. for 1+3, enter 4.
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.
Protected by Spam Master