Add new comment

Submitted by Steve on Wed, 02/19/2020 Permalink

just installed a BLTouch v3.1 and I'm using the Petsfang V2 mounting bracket on the left side of my Ender 3.  I have tried many times to add the offsets for the probe to the firmware but no luck compiling a viable HEX file.  I think this is why I'm getting so many probing failures.  According to the post on Thingiverse, these are the offsets:

v2 BLTOUCH........................X......-42................Y......-5

Could you compile your HEX file to include these offsets?  

The content of this field is kept private and will not be shown publicly.