Add new comment

Hi Daniel,

 

Turns out it was badly flashed (my mistake...), flashed it correctly with the precompiled firmware using the USBISP from creality on settings DC D6 FD and its perfect now! Thank you!

Ohh and for anyone reading this with what i have (glass bed, new springs, bltouch 3.1 and everything configured) and using Cura 4.4, make sure you set the X and Y offset on it. The print was coming very off from the center but i managed to balance it by setting X: -5 and Y -8.5, it now prints in the center.

The content of this field is kept private and will not be shown publicly.