Add new comment

Submitted by Ben on Sun, 02/16/2020 Permalink

Before i begin, thank you so much for putting your time and effort on all of this.

 

The problem i'm having is that i flashed it perfectly and did everything right but when it finishes to level the bed, it gives me an error saying "maxtemp:bed printer halted"
I checked the sensors and all are working fine, reflashed and still doing the same. I even just leveled it with the minimal temps on the bed and its still saying that error.

Any ideas what it can be? (note this happens with the normal level bed way or the custom command way)

 

The content of this field is kept private and will not be shown publicly.