g1 z0 after g28 it put the nozzle up super high so I, thought, had to move it to 0
then leveled the 4 corners and center as if i were a manual leveling bed which is moving the bed and nozzle to the corners and middle and using a piece of paper. I did not put it so low to catch but just enough that it was close (I didnt have a credit card or anything of similar width at the time).
then when I tried to run a test print from Cura, it tried to lay down the primer line, then tried to print way off to the left side, causing the machine to lock up.
I ran g28 g1 z0 after g28 it…
I ran
g28
g1 z0 after g28 it put the nozzle up super high so I, thought, had to move it to 0
then leveled the 4 corners and center as if i were a manual leveling bed which is moving the bed and nozzle to the corners and middle and using a piece of paper. I did not put it so low to catch but just enough that it was close (I didnt have a credit card or anything of similar width at the time).
then when I tried to run a test print from Cura, it tried to lay down the primer line, then tried to print way off to the left side, causing the machine to lock up.
Thanks.