Add new comment

I reflashed the board. installed new marlin. manually leveled the bed at -2.24, sent commands through the terminal. Ran g29, got reasonable values back. m500 to save them. then ran G1 X10.1 Y200.0 Z0 F1500.0 E15, which tried to print in the air above the bed. changed it to G1 X10.1 Y200.0 Z-2.24 F1500.0 E15 it tried to print but the offset is a bit too low. I tried making changes to the firmware before upload and nothing will compile. I've tried VS Code and arduino..Doesn't seem like it should be this hard but I am obviously out of my depth.

Now to figure out how to reset it all back to factory settings.....hopefully I can get this to work otherwise I have an expensive paperweight.

The content of this field is kept private and will not be shown publicly.