Add new comment

The firmware does not probe the bed before every print, your print initialization GCode is responsible for that. This setting is not enabled by default, It seems you enabled it by following another tutorial.

Here is how to fix that:

  • Go to the printer configuration in your slicer and make sure there is no G29 command in the initalization GCode. If you see, erase the line.
  • In the same printer configuration add the command M420 S1 as a new line just after the G28 command line. This will load the previously saved Bed Level settings.

You are done! Don't forget to re-slice previous models that probably came with the G29 command embed in the code.

The content of this field is kept private and will not be shown publicly.