G28 (Home command) reset question I see in your notes, you advertise: Does not reset the bed level settings after the G28 (Home) command. But looking at the source code, I see in Configuration.H that: //#define RESTORE_LEVELING_AFTER_G28 .... is still disabled. I'm VERY new to this (flashing my ender for the first time tonight), but is that right? I "do" see in Configuration_adv.h that: #define RESTORE_LEVELING_AFTER_G34 ... is ENABLED, but that's something completely different, right? G34 is like z-stepper auto-alignment?? Reply
G28 (Home command) reset question
I see in your notes, you advertise:
Does not reset the bed level settings after the G28 (Home) command.
But looking at the source code, I see in Configuration.H that:
//#define RESTORE_LEVELING_AFTER_G28 .... is still disabled. I'm VERY new to this (flashing my ender for the first time tonight), but is that right?
I "do" see in Configuration_adv.h that:
#define RESTORE_LEVELING_AFTER_G34 ... is ENABLED, but that's something completely different, right? G34 is like z-stepper auto-alignment??