Acceleration values for E? I just did a diff of my Ender 3 Pro stock settings as reported by M503 and what is burned into this hex. Aside from slightly less conservative settings for jerk in my stock firmware, this stood out: Recv: echo:Maximum Acceleration (units/s2): Recv: echo: M201 X500 Y500 Z100 E5000Acceleration for the Extruder is 5x (!) that of the stock firmware (1000mm/s² there). Judging from the other parameters, could this be a typo and the intend was for this to be 500? Thanks! Hajo Reply
Acceleration values for E?
I just did a diff of my Ender 3 Pro stock settings as reported by M503 and what is burned into this hex.
Aside from slightly less conservative settings for jerk in my stock firmware, this stood out:
Acceleration for the Extruder is 5x (!) that of the stock firmware (1000mm/s² there). Judging from the other parameters, could this be a typo and the intend was for this to be 500?
Thanks!
Hajo