Thanks for your answer. I've tried erasing the EEPROM using `M502` followed by `M500` several times, unfortunately to no avail. I am starting to think this might be a board issue, I just tried with Creality provided BLTouch firmware (not as awesome as yours of course) and I have the exact same problem. I tried so many things that the only thing left could be hardware related. The probe itself is doing fine and the leveling goes without a hitch when I follow it up close with the terminal output next ot it. No failures during probing.
It seems I'm in need of an upgraded board (I still have the stock melzi 8-bit). I'm not sure if that is the problem but it's the only other thing I can think of.
For now a 'workaround' is to include G29 in my print start gcode, then the print results are perfect.
Hi Daniel Thanks for your…
Hi Daniel
Thanks for your answer. I've tried erasing the EEPROM using `M502` followed by `M500` several times, unfortunately to no avail. I am starting to think this might be a board issue, I just tried with Creality provided BLTouch firmware (not as awesome as yours of course) and I have the exact same problem. I tried so many things that the only thing left could be hardware related. The probe itself is doing fine and the leveling goes without a hitch when I follow it up close with the terminal output next ot it. No failures during probing.
It seems I'm in need of an upgraded board (I still have the stock melzi 8-bit). I'm not sure if that is the problem but it's the only other thing I can think of.
For now a 'workaround' is to include G29 in my print start gcode, then the print results are perfect.