First of all thank you for all your work on this configuration of marlin and for making it freely available. I was double checking the firmware and noticed that you have EEPROM_CHITCHAT disabled. I know why you disabled it. With EEPROM_CHITCHAT enabled the file is to large for the 8-bit board, but does disabling this not prevent services like octoprint from receiving feed back from the printer? If I have to enable this to get octoprint to work what would you recommend I disable to get the compiled file size down? Thank you again this is my first time configuring marlin for my 3d printer. I learned a lot by going through your guide.
Will this firmware work with octo print?
First of all thank you for all your work on this configuration of marlin and for making it freely available. I was double checking the firmware and noticed that you have EEPROM_CHITCHAT disabled. I know why you disabled it. With EEPROM_CHITCHAT enabled the file is to large for the 8-bit board, but does disabling this not prevent services like octoprint from receiving feed back from the printer? If I have to enable this to get octoprint to work what would you recommend I disable to get the compiled file size down? Thank you again this is my first time configuring marlin for my 3d printer. I learned a lot by going through your guide.