Hey Daniel, thanks for making a stellar guide for updating firmware!
I flashed the version for TMC drivers, and it worked fine. I leveled my bed, which is insanely level now (largest deviation is around 0.16mm according to mesh). Probed it to generate mesh and saved the mesh. Added M420 S1 after G28 in gcode, and went on my happy way until i noticed the mesh is not being used when printing. I tried to print some leveling files, touched the z driver and it's not moving to compensate. Got any ideas how i can solve this?
Bltouch 3.1, Mainboard 1.1.5 - Mesh not being used when printing
Hey Daniel, thanks for making a stellar guide for updating firmware!
I flashed the version for TMC drivers, and it worked fine. I leveled my bed, which is insanely level now (largest deviation is around 0.16mm according to mesh). Probed it to generate mesh and saved the mesh. Added M420 S1 after G28 in gcode, and went on my happy way until i noticed the mesh is not being used when printing. I tried to print some leveling files, touched the z driver and it's not moving to compensate. Got any ideas how i can solve this?