Visual studio code instructions item 5. #define NOZZLE_TO_PROBE_OFFSET { -42, -5, 0 } is not present in configuration.h to edit. Do I change these lines instead(45mm was what I measured)? #define X_PROBE_OFFSET_FROM_EXTRUDER -45 // X offset: -left +right [of the nozzle] Customized DBP #define Y_PROBE_OFFSET_FROM_EXTRUDER -5 // Y offset: -front +behind [the nozzle] Customized DBP #define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle] Customized DBP Reply
Visual studio code instructions item 5.
#define X_PROBE_OFFSET_FROM_EXTRUDER -45 // X offset: -left +right [of the nozzle] Customized DBP
#define Y_PROBE_OFFSET_FROM_EXTRUDER -5 // Y offset: -front +behind [the nozzle] Customized DBP
#define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle] Customized DBP