Add new comment

Submitted by Chris on Mon, 07/20/2020 Permalink

I'm using this on a Creality 1.1.5 Silent Board (on an Ender 3). Works absolutely fantastic! I've run into a problem which might be hardware related instead of firmware, but looking for some help.



Every time I shut the printer down, when I turn it back on, I get the blue screen and it won't boot up. The only fix I've found is to reload the firmware every time I turn the printer back on (tedious!). It always runs great, but it won't retain the firmware. It's absolutely fine as long as I never shut the printer down. Thoughts?

The content of this field is kept private and will not be shown publicly.
CAPTCHA
15 + 2 =
Solve this simple math problem and enter the result. E.g. for 1+3, enter 4.
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.
Protected by Spam Master